2025/2026 SDI FIREARM FINISHES AND ENGRAVING (FTT 201) ACTUAL Q&A 100% PASS

Inside The Document

2025/2026 SDI FIREARM FINISHES AND ENGRAVING (FTT 201) ACTUAL Q&A 100% PASS T/F: One possible indicator that a barrel is likely to shoot poorly is pitting near the crown. - Answer -TRUE Lands in the throat are which are uneven in their short points are usually caused by: - Answer -Cleaning Rod Damage According to Joe Carlos, what must you do with a barrel to know for certain what its current capabilities are? - Answer -Shoot It T/F: The electropolishing process both improves barrel accuracy and is safe for the environment. - Answer -FALSE Joe Carlos' experiment showed that electropolishing was: - Answer -Effective for Increasing the Accuracy of Damaged Barrels The fire lapping process involves: - Answer -Firing cartridges with progressively finer grit abrasive coated bullets, which effectively polishes the bore. T/F: Fire lapping has about the same average effective improvement on accuracy as electropolishing. - Answer -TRUE There is generally more need for fire lapping in: - Answer -Button Rifled Bores Need assistance on Online classes, Exams & Assignments? Reach out for instant help!! Full Course Assistance, Plagiarism-free Essay Writing, Research Paper, Dissertation, Discussion Posts, etc…. Confidential & Secure services. Tutors are available for all subjects! Email now at: tutorjean01@gmail.com T/F: Fire lapping does not remove metal from the barrel. - Answer -FALSE "Throat maintenance" bullets were found through extensive testing to: - Answer -Have a reliably positive impact on accuracy The two basic metal preparation processes, according to Frank Fry, are: - Answer -Hand and Machine The first of three steps to hand finishing is: - Answer -Remove machine marks with files Which of the following wheel types used in machine polishing will cut the fastest? - Answer -Felt To prevent the loss of or "pulling" of letters and numbers, these areas should be polished by: - Answer -Hand When using a wheel for polishing: - Answer -Always polish with sharp edges pointed in the same direction the wheel is turning. If stamping has been damaged or pitted, you should: - Answer -Leave the damaged stamping alone Nickel plating has been a popular finish for handguns and certain small parts of long guns since the turn of the century. The finish is applied by a process called: - Answer -Electroplating For basic polishing: protect all of the newly-polished surfaces from rusting with which of the following until you are ready to apply the bluing solution: - Answer -Light Coat of Oil In general, power polishing entails starting which of the following grits and polishing the surface of the metal in a given direction: Need assistance on Online classes, Exams & Assignments? Reach out for instant help!! Full Course Assistance, Plagiarism-free Essay Writing, Research Paper, Dissertation, Discussion Posts, etc…. Confidential & Secure services. Tutors are available for all subjects! Email now at: tutorjean01@gmail.com